Skip to main content
HVAC service in Hyattsville, MD: technician reviewing a homeowner's thermostat settings
Serving Hyattsville, MD

HVAC Service in Hyattsville, MD

Most houses around the Hyattsville historic district had radiators for decades before anyone added cooling. We repair, replace and install heating and cooling in those houses, where the AC was fitted in later, and in the newer ones nearby.

What to know about HVAC Service in Hyattsville

A city permit on top of the county one

The Hyattsville Historic District went on the National Register in 1982 with close to a thousand buildings. Exterior work there takes a City of Hyattsville permit on top of the Prince George's County one, including a condenser pad or a line set on a visible wall.

Cooling a house built without ducts

Houses from the 1920s through the 1940s came with radiators or a single floor furnace. Cooling means attic ducts, a high velocity system or ductless heads, each with its own electrical and condensate plan. Size the load first, then pick the method.

Hyattsville was built for radiators

The streets around the historic district and the Route 1 Arts District are full of houses from before central air.

Repairs here usually mean fixing modern equipment that was fitted into an old house later. Know what was added and when.

The local concept

The retrofit attic

A retrofit attic is an attic that was never meant to hold equipment but now carries an air handler and ducts added decades after the house was built.

In Hyattsville's older houses that attic is often low, hot and hard to reach. That is why filters get skipped, drains clog and coils ice. Better access makes every future repair easier and cheaper.

If the attic hatch is in a closet ceiling and the unit sits behind a maze of rafters, say so when you book. The visit gets planned around the access, not discovered on the day.

Hyattsville repairs, house by house

Attic air handler trouble

An air handler in a low attic overheats, clogs its drain and freezes its coil. Most of these calls start with water on a ceiling or air that stops cooling.

Post-war houses on the west side

In the neighborhoods around the West Hyattsville Metro station and University Hills, most calls are furnace and AC repairs on standard ducted systems.

Condos near Hyattsville Crossing

Owners and renters in the apartments and condos near the Hyattsville Crossing Metro station and the Mall at Prince Georges call about closet systems, thermostats and drains.

Ductless heads in old houses

Houses near Magruder Park that added ductless heads need their filters washed and their drains kept clear. Neglected heads drip and smell.

Arts District townhouses

Newer townhouses along Route 1 in the Arts District have compact systems that need regular tune-ups and correct thermostat setup.

Old floor furnaces and radiators

Some Hyattsville houses still have a floor furnace or a boiler on radiators. Replacing an old floor furnace or adding cooling around a boiler starts with a load check of the whole house.

Popular HVAC services in Hyattsville

Most Hyattsville calls are repairs on equipment fitted into older houses, from the historic district to the Route 1 corridor.

Areas served around Hyattsville

We cover the City of Hyattsville and the Prince George's County neighborhoods around it, from the historic district to University Hills.

Hyattsville Historic DistrictArts DistrictWest HyattsvilleUniversity HillsQueens Chapel ManorCastle ManorHyattsville HillsKirkwoodCollege Heights Estates

From Bryans Road to Hyattsville

Hyattsville lies about 22 miles from our Bryans Road shop in a straight line.

The route is MD 210 north, then I-295 and DC 295 along the Anacostia River, then through Bladensburg to US 1 in Hyattsville.

Map of Hyattsville and the route from All Purpose HVAC in Bryans Road, MDThe City of Hyattsville is shaded, with the Hyattsville Crossing and West Hyattsville Metro stations, the Mall at Prince Georges and Magruder Park marked. A dashed line runs about 22 miles south to the All Purpose HVAC shop in Bryans Road, Maryland. The route follows MD 210 north, I-295 and DC 295 along the Anacostia River, then through Bladensburg to US 1 in Hyattsville.Potomac RiverAnacostia RiverPatuxent RiverOccoquan RiverMD 210I-295DC 295US 1about 22 milesHyattsvilleAll Purpose HVACBryans Road, MD5 milesN
Close-up of Hyattsville.
© OpenStreetMap contributorsGet directions

Hyattsville HVAC questions

Can you add central air to a pre-war Hyattsville house?

⌄
Yes. Houses from the 1920s to the 1940s were built with radiators or a floor furnace. Cooling means attic ducts, a high velocity system or ductless heads. We size the load first, then pick the method.

Do I need an extra permit in the Hyattsville Historic District?

⌄
For exterior work, yes. A property in the district takes a City of Hyattsville permit on top of the Prince George's County one. That can include a condenser pad or a line set on a visible wall.

Water is dripping from my ceiling under the attic air handler. What is wrong?

⌄
Usually a clogged condensate drain or a full drain pan. Turn the system off at the thermostat and call us to clear the drain and check the pan.

Do you repair ductless mini splits in Hyattsville?

⌄
Yes. We repair and service ductless heads and their outdoor units across Hyattsville.

How far is Hyattsville from your shop?

⌄
About 22 miles. I-295 and DC 295 carry us up the east side of the District, then Bladensburg leads to US 1.

My Hyattsville house has a high velocity system. Can you repair it?

⌄
Yes. High velocity systems use small flexible ducts and a compact air handler. Repairs follow the same diagnosis as any central system, with parts sized to that equipment.

Do I need a city permit for a new condenser in the historic district?

⌄
For a property in the Hyattsville Historic District, exterior equipment can need a City of Hyattsville permit on top of the county one. We check before the unit is set.

Request HVAC Service in Hyattsville

Send the form or call (240) 695-4415, 7:00 AM to 7:00 PM daily.

We take insurance jobs. Financing may also be available for qualifying projects. Ask when you call.